How to Flash Realme Firmware Using Realme Flash Tool

Realme Flash Tool is an official Windows utility provided by Realme for flashing stock firmware on supported Realme smartphones. It is mainly used to restore official software, fix bootloops, or recover devices that fail to boot properly.

This guide explains how to flash Realme firmware using Realme Flash Tool safely, including supported devices, requirements, flashing steps, and common limitations.

Who This Guide Is For

Use this guide only if all conditions below apply:

✔ You are using a supported Realme smartphone
✔ Your device firmware is provided in .ofp or .ozip format
✔ You are using a Windows PC
✔ Your device model is officially supported by Realme Flash Tool

Do NOT use this guide if:

❌ Your Realme device is not listed as supported
❌ Your firmware format is incompatible
❌ Your bootloader is locked, and flashing is restricted
❌ You are trying to flash firmware for another Realme model

⚠️ Warnings & Important Limitations

Flashing firmware will erase all user data
Flashing the wrong firmware can hard-brick your device
Realme Flash Tool has strict device and region restrictions
Not all Realme models support flashing via this tool
Some Realme firmware requires authorized flashing

FlashGuideHub does not host firmware files. Always verify that the firmware is official and intended for your exact Realme model and region.

Requirements

Before starting, make sure you have the following:

Windows PC or Laptop
Reliable USB cable
Realme Flash Tool (compatible version)
Realme USB Drivers installed
Correct Realme firmware file (.ofp or .ozip)
At least 50% battery charge

Preparation Steps

Install Realme USB Drivers on your PC
(Restarting the PC afterward is recommended.)
Extract the Realme Flash Tool archive.
Place the firmware file in an easily accessible folder.
Power off the Realme device completely.

Step-by-Step: Flashing Firmware with Realme Flash Tool

Step 1: Launch Realme Flash Tool

Open the extracted Realme Flash Tool folder
Run RealmeFlashTool.exe as Administrator

The tool interface should now load.

Step 2: Load Firmware File

Click Browse or Select Firmware
Locate and select the .ofp or supported firmware file
Confirm the firmware is loaded successfully

Step 3: Boot Device into Flashing Mode

Power off the phone
Boot the device into Fastboot / Download mode
(Key combinations vary by model)
Connect the device to the PC using USB
Click “Loading device” to detect the phone.

If drivers are installed correctly, the tool should detect the device.

Step 4: Start Flashing

Click Start to begin flashing
Do not disconnect the device during the process

Flashing typically takes 5–10 minutes.

Step 5: Completion & First Boot

Once flashing completes successfully:

Disconnect the USB cable
Power on the device
Wait patiently — first boot may take longer than usual

Common Realme Flash Tool Issues

If flashing fails, common causes include:

❌ Unsupported Realme model
❌ Incorrect firmware file
❌ Locked bootloader restrictions
❌ Missing USB drivers
❌ Region mismatch
❌ Faulty USB cable or USB port

Many Realme devices cannot be flashed freely due to OEM security restrictions.

Post-Flash Checklist

After flashing:

Complete Android setup
Verify Realme UI / Android version
Confirm network signal and IMEI
Factory reset if boot issues occur

Frequently Asked Questions

Does Realme Flash Tool unlock the bootloader?

No. Bootloader unlocking is a separate and restricted process.

Does Realme Flash Tool work on all Realme phones?

No. Support depends on model, chipset, and region.

Can Realme Flash Tool fix bootloops?

Yes — if the device and firmware are officially supported.

Final Notes

Realme Flash Tool is an OEM-specific flashing solution with strict limitations. Always confirm device compatibility before flashing and never attempt to flash firmware intended for another model.